Call Us Today: 800.326.8406  |  Email Us: info@uapc.com
Custom Compression
Systems & Components
All Categories > Products > Dry Electrostatic Precipitators > i3-Industrial Standard Precipitators - 3 Ton through 8 Ton Units > Item # i3-32H2  
    Printable Page     Email Email This Page     Save To Favorites Save To Favorites

Item # i3-32H2, I3-Industrial Standard Precipitators - 8 Ton Unit


Industrial Standard Precipitators - Model Series: i3 (In-Duct, Spray Wash) - 3 Ton through 8 Ton Units

I-series: Like the Commercial (C-series), the industrial, in-duct designs use housing or cabinet structures to support the cells installed within them. The galvanized cabinet structure can be factory finished on it exterior in enamel at the customers option. Seal welding of the cabinet is also available at option and required for UL710 ductwork installations. Again, In-duct design means that the precipitator is supplied without an air handler and will be cut into a section of horizontal flow ductwork. Commercial cell designs are typically applied to applications where frequent and aggressive cleaning of the cells will not be required.




Specifications  · Cabinet Dimensions  · Integral Wash System  · Additional Information  · Note  · SEO

Specifications

Air Flow Capacity
90.6 m³/min
3200 ft³/min

Rated Efficiency
90 %

Air Conditioner Capacity
8 tons

Air Flow Resistance (wg)
0.1 in


Cabinet Dimensions

W - Width
36 3/16 in

X - Duct Opening
32 11/16 in

Y - Height
41 1/2 in

Z - Duct Height
34 3/8 in

Cell Removal Clearance
20 in

Approximate Shipping Weight
300 lb

Power Package Quantity
2

Voltage
115 V

Frequency
60 Hz

Power (Per Pack)
25 W


Integral Wash System

Water Inlet
3/4 in

Drain Flange (Iron Pipe Size (IPS))
2 in

Water Required at 40 Pound per Square Inch (PSI) Per Tier
14 gpm


Additional Information
The I-series has the same efficiency as the commercial or C-series, however it is sturdier. Due to its higher cost, some customers opt for the C-series over the I-series. In overview, the I-series cell uses twelve tie rod supports for the collector plates; its ionizing section is supported without ceramic insulators; and its end plates are made of heavy gage aluminum. Otherwise, the I-series cell has collector plates, spacers and an ionizing section that are identical with the materials and dimensions of the residential and industrial cell designs.


Note
UAPC is committed to on-going improvement. Dimensions & specifications are subject to change without prior notification.


SEO

Manufacturer
Universal Air & Gas


 DOWNLOADS 

Installation and Operations Manual (CI-1a)
(PDF, 65KB)

Brochure for C3-Commercial Standard Precipitators - 3 Ton Through 8 Ton Units
(PDF, 851KB)

Features
(PDF, 41KB)

Technical Data for i3-Industrial Standard Precipitators
(PDF, 71KB)

Dimensional Drawings (C/I-32H2)
(PDF, 219KB)


Universal Air & Gas Products Corp. | Quality Equipment & Service Since 1962