Call Us Today: 800.326.8406  |  Email Us: info@uapc.com
Custom Compression
Systems & Components
All Categories > Products > Dry Electrostatic Precipitators > C3-Commercial Standard Precipitators - 24 Ton Through 40 Ton Units > Item # C3-160H4  
    Printable Page     Email Email This Page     Save To Favorites Save To Favorites

Item # C3-160H4, C3-Commercial Standard Precipitators - 40 Ton Unit


Commercial Standard Precipitators - Model Series: C3 (In-Duct, Integral Spray Wash) - 24 Ton Through 40 Ton Units

C-series: Commercial and industrial, in-duct designs use identical housing or cabinet structures made of galvanized steel to support the cells installed within them. The galvanized cabinet structure can be factory finished on its exterior in enamel at the customer's option. Seal welding of the cabinet is also available at its option. In-duct design means that the precipitator is supplied without an air handler and will be cut into a section of horizontal flow ductwork. Commercial cell designs are typically applied to applications where frequent and aggressive cleaning of the cells will not be required.




Specifications  · Cabinet Dimensions  · Integral Wash System  · Additional Information  · Note  · SEO

Specifications

Air Flow Capacity
453.1 m³/min
16000 ft³/min

Rated Efficiency
90 %

Air Conditioner Capacity
40 tons

Air Flow Resistance (wg)
0.1 in


Cabinet Dimensions

W - Width
87 in

X - Duct Opening
83 5/8 in

Y - Height
78 1/2 in

Z - Duct Height
71 3/8 in

Cell Removal Clearance
25 in

Approximate Shipping Weight
1140 lb

Power Package Quantity
4

Voltage
115 V

Frequency
60 Hz

Power (Per Pack)
95 W


Integral Wash System

Water Inlet
1 in

Drain Flange (Iron Pipe Size (IPS))
2 in

Water Required at 40 Pound per Square Inch (PSI) Per Tier
39 gpm


Additional Information
The C-series is just as efficient as the industrial or I-series, however it is not as mechanically sturdy. Due to its lower cost, some customers opt for the C-series over the I-series. In overview, the C-series cell uses eight tie rod supports for the collector plates; its ionizing section is supported without ceramic insulators; and its end plates are made of galvanized steel. Otherwise, the C-series cell has collector plates, spacers and an ionizing section that are identical with the materials and dimensions of the residential and industrial cell designs.


Note
UAPC is committed to on-going improvement. Dimensions & specifications are subject to change without prior notification.


SEO

Manufacturer
Universal Air & Gas


 DOWNLOADS 

Installation and Operations Manual (CI-1a)
(PDF, 65KB)

Brochure for C3-Commercial Standard Precipitators - 3 Ton Through 8 Ton Units
(PDF, 851KB)

Features
(PDF, 41KB)

Equipment Prices
(PDF, 51KB)

Technical Data for C3-Commercial Standard Precipitators
(PDF, 73KB)

Datasheet (C3-160H4)
(DOC, 204KB)

Dimensional Drawings (C/I-160H4)
(PDF, 406KB)


Universal Air & Gas Products Corp. | Quality Equipment & Service Since 1962