Universal Air & Gas Products Corp.
1140 Kingwood Avenue Norfolk, Virginia 23502-5603
Toll Free: 1.800.326.8406 • Phone: 757.461.0077 • Fax: 757.461.0808
Email: info@uapc.com • Web Address: www.uapc.com
All Categories > Products > Dry Electrostatic Precipitators > C3-Commercial Standard Precipitators - 10 Ton Through 22 1/2 Ton Units > Item # C3-72H3  


Item # C3-72H3, C3-Commercial Standard Precipitators - 18 Ton Unit

Commercial Standard Precipitators - Model Series: C3 (In-Duct, Integral Spray Wash) - 10 Ton Through 22 1/2 Ton Units

C-series: Commercial and industrial, in-duct designs use identical housing or cabinet structures made of galvanized steel to support the cells installed within them. The galvanized cabinet structure can be factory finished on its exterior in enamel at the customer's option. Seal welding of the cabinet is also available at its option. In-duct design means that the precipitator is supplied without an air handler and will be cut into a section of horizontal flow ductwork. Commercial cell designs are typically applied to applications where frequent and aggressive cleaning of the cells will not be required.





Specifications  · Cabinet Dimensions  · Integral Wash System  · Additional Information  · Note  · SEO

Specifications

Air Flow Capacity
203.9 m³/min
7200 ft³/min

Rated Efficiency
90 %

Air Conditioner Capacity
18 tons

Air Flow Resistance (wg)
0.1 in


Cabinet Dimensions

W - Width
51 5/16 in

X - Duct Opening
47 13/16 in

Y - Height
60 in

Z - Duct Height
52 7/8 in

Cell Removal Clearance
27 in

Approximate Shipping Weight
500 lb

Power Package Quantity
3

Voltage
115 V

Frequency
60 Hz

Power (Per Pack)
50 W


Integral Wash System

Water Inlet
3/4 in

Drain Flange (Iron Pipe Size (IPS))
2 in

Water Required at 40 Pound per Square Inch (PSI) Per Tier
22 gpm


Additional Information
The C-series is just as efficient as the industrial or I-series, however it is not as mechanically sturdy. Due to its lower cost, some customers opt for the C-series over the I-series. In overview, the C-series cell uses eight tie rod supports for the collector plates; its ionizing section is supported without ceramic insulators; and its end plates are made of galvanized steel. Otherwise, the C-series cell has collector plates, spacers and an ionizing section that are identical with the materials and dimensions of the residential and industrial cell designs.


Note
UAPC is committed to on-going improvement. Dimensions & specifications are subject to change without prior notification.


SEO

Manufacturer
Universal Air & Gas



Print Back