Universal Air & Gas Products Corp.
1140 Kingwood Avenue Norfolk, Virginia 23502-5603
Toll Free: 1.800.326.8406 • Phone: 757.461.0077 • Fax: 757.461.0808
Email: info@uapc.com • Web Address: www.uapc.com
All Categories > Products > Dry Electrostatic Precipitators > Self-Contained Standard Precipitators - 800 Though 6000 CFM > Item # Mi-10  


Item # Mi-10, Self-Contained Standard Precipitators - 1000 CFM

Self-Contained Standard Precipitators - Model Series: Mi (with Integral Blower/Motor Assembly)- 800 Though 6000 CFM

Mi-series: This product range is self-contained, utilizing its own built in squirrel cage blower and motor assembly. Typically the units are free standing or suspended from the ceiling. Source capture applications use a pickup hose assembly to draw mist or smoke directly from it source and into the precipitator for cleaning much like a vacuum cleaner.





Specifications  · Blower Motor  · Power Requirements  · Air Cleaner Specifications  · Ionizer Specifications  · Other Options Available  · Additional Information  · Note  · SEO

Specifications

Nominal Rating1
28.3 m³/min
1000 ft³/min

Cabinet Material
16 gauge, Cold Rolled Steel (Std.)
Primed with Enamel Finish

Cell(s) Material
Aluminum (Std.)
Hastelloy
Stainless Steel

Unit Weight
225 lb

Height
23 in

Length
41.5 in

Width
23 in

Inlet Duct Height
15.5 in

Inlet Duct Width
20.375 in

Outlet Duct Height
10 in

Outlet Duct Width
12 in

Collecting Cell Height
18 in

Collecting Cell Width
21.25 in

Collecting Cell Depth
12.5625 in

Collecting Cell Weight
32 lb

Unit Operating Current Range
0.4 to 0.9 mA

Collector Direct Current (DC) Voltage
7200 to 8800 V

Ionizer Voltage Gradient (DC) at 8000 Volt (V) Direct Current (DC) Voltage
11158 V/in

Collector Voltage Gradient (DC) at 8000 Volt (V) Direct Current (DC) Voltage
24768 V/in

Collector Plates Insulator and Diameter
Collector plates are suspended with four, 2.25" diameter ceramic insulators.

Power Pack Description
Solid state design, controls include: circuit breaker with manual reset, LED
Power on light, ammeter, variable rheostat, safety interlock switch. Power packs can be unit or remote mounted.

Power Package Quantity
1

Pre & Post Filter
Washable, aluminum mesh mechanical pre-and post cell filters.
1 Consult with factory or an authorized representative for proper model selection.


Blower Motor

Motor Type
Open Drip Proof (ODP) (Standard)
Totally Enclosed, Fan-Cooled (TEFC)

Motor Power
1/4 hp

Motor Speed
1725 rpm

Electrical Design
50 Hz or NEMA 3, 4, 4X or 12
NEMA 1, 60 Hz (Std)

Motor Drive Design
Flexible V-Belt
Variable Sheave

Blower Type
Forward cure with sealed ball bearings mounted with rubber grommets to reduce noise and vibration; belt driven.

Blower Power
675 rpm


Power Requirements

Voltage
115 V
220 V

Frequency
50 Hz
60 Hz

Phase
1


Air Cleaner Specifications

Air Cleaner Type
Two stage, dry, electrostatic precipitator

Efficiency
Atmospheric dust spot 91%; Cold DOP 96%

Efficiency Test Method
ASHRAE 52-76

Quantity at Cell Size - Each
1 x 1000 ft³/min

Total Collector Plate Surface
9688 in²

Plate Spacing
0.323 in

Air Velocity
415 ft/min


Ionizer Specifications

Ionizer Direct Current (DC) Voltage
7200 to 8800 V

Ionizer Type
Integral to collecting cell, supported without ceramic insulators, tungsten wire electrodes (standard), optional electrode materials available.

Ionizer Electrode Diameter
0.007 in

Ionizer Suspension
Stainless steel wire springs at each electrode end.


Other Options Available

Portable Designs
Contact factory for information on the Mi-10P series portable air cleaners.

Water Wash Manifolds
Copper manifold (pipe) with wide angle spray nozzles; single side wash.

System Cleaning
Fully Automatic Wash and Dry Cycle with or without detergent injection.
Manually Initiated

Source Capture Plenums
Specifically designed for the application

Filter Manifolds
Pre and post filter racks designed per requirement for HEPA or charcoal.

Electrical Controls
Custom designed options in relay logic or PLC


Additional Information
Mi-series units are built only with industrial cells as described above under the I-series. Blower and motor assemblies are designed to accommodate the SCFM throughput of the application with consideration for internal and external static pressure losses. Mi-series housings are made of cold rolled steel that is primed and finished in enamel. Single tier and two tier configurations are available in sizes ranging from 800-CFM to 6000-CFM.


Note
Technical data and design features are subject to change without prior notification
Consult factory for larger models.


SEO

Manufacturer
Universal Air & Gas



Print Back